Xi'an Jiaotong Inverted Perovskite Cell Reaches 27.96% Efficiency
- A Xi'an Jiaotong University-led team reports a 27.96% certified inverted perovskite cell in Nature.
- A perovskite-silicon tandem made with the same interface molecule reached 34.71% stabilized output.
- Both cells are lab-sized; the single-junction cell measured 0.0528 cm².
A team led by Xi'an Jiaotong University has reported an inverted perovskite solar cell with a certified efficiency of 27.96%, in a paper published in Nature on Nov. 18. A perovskite-silicon tandem built with the same method reached a certified stabilized output of 34.71%.
The work targets the contact between the perovskite absorber and the C60 layer that carries electrons out of the cell. Common ammonium-salt treatments heal surface defects there, but their insulating parts slow the electrons down. The team designed fully conjugated formamidinium molecules instead. The best of them, called BTFI, couples with the perovskite's electronic states; in films with C60, it made charge-transfer dynamics about 3.8 times faster than a standard ammonium salt, the university said.
The cells are small. The Tianjin Institute of Metrological Supervision and Testing certified a single-junction cell with a 0.0528-cm² active area, according to the supplementary data. The SIMIT test lab measured the tandem on 97.24 mm², just under 1 cm².
Neither the paper nor the university calls the result a record. The efficiency chart of the National Laboratory of the Rockies, formerly NREL, lists 28.0% as the best single-junction perovskite cell and 35.2% for perovskite-silicon tandems. Soochow University and LONGi reported a 35.1% tandem in Nature two weeks earlier.
The cell in numbers
- 27.96% certified on the reverse scan, 27.32% on the forward scan and 27.84% stabilized output for the single-junction cell.
- 0.0528 cm² of active area, set by a thin metal aperture mask.
- 34.71% certified stabilized output for the tandem, with 34.74% on the reverse scan and 2.009 V open-circuit voltage.
- More than 95% of initial efficiency kept after 2,000 hours of maximum-power-point tracking under 1-sun light, unencapsulated, in nitrogen at about 45°C.
- 0.04 percentage points below the 28.0% best perovskite cell on the NLR chart (list.solar calculation).
- 0.49 percentage points below the chart's 35.2% perovskite-silicon tandem (list.solar calculation).
The university's State Key Laboratory for Mechanical Behavior of Materials is the lead institution. Six corresponding authors include Yuhang Liu of Xi'an Jiaotong and Michael Grätzel of EPFL in Lausanne. Researchers from Fudan University, the National University of Singapore, Northwestern Polytechnical University and a CNPC research institute also took part.
The stability test ran in nitrogen on bare cells, not in open air or outdoors. The study covered lab cells only and gave no plan for larger devices or commercial panels.
Also read
- LONGi to Supply Hi-MO 9 Modules for 176-MWdc Muswellbrook Solar Farm
- Korea's EAV-4 Solar Drone Flies 170 Hours Nonstop in Stratosphere
- Ember Finds Wind Cuts Cost of Near-Firm Solar and Batteries by 18%
- EPFL Builds First Organic Photocatalyst Sheet That Splits Water
- Eight Lenders Sign Support Letter for Acwa's 2-GW Türkiye Solar